Ice Amplifiers

Figure 1: The supply is mounted on the bottom face of the cabinet, using "studyposts" the toroidal transformer is smaller than is EI counterpart and has lower leakage flux, although that is of no concern as it is far away from the small signal stages. The shot shows clearly the effort taken to ensure low noise, the power amp sits on the right of the cab as the front of the cab faces the camera (see Figure 3) all of the high current (and therefore potentially noise generating wiring is run up the right side of the cab well away from the pre amp. Of course if the grounding is not properly attended two all the distance in the world will not help as the hum will be a conducted emission in the power supply wires as opposed to a radiated emission which is what the distance between PSU and small signal stages is trying to improve. Distance is very effective (if you can spare it) as the effects of electromagnetism are proportional to the distance squared. Still further improvement could be obtained by twisting the sets of wires together to form a twisted pair. A pistol drill and vice are useful for achieving a professional look. icenlemon10